About Us

Sea-Legs Pontoon Boat Lift



The Pontoon Lift That Goes Where You Go!

Raise your Sea-Legs™ and go
Lower your Sea-Legs and park at your dock, sandbars, restaurants, visiting neighbors,
shore fishing, getting gas and more!

Sea-Legs are the world's only portable hydraulic pontoon lift. The product consists of two hydraulically operated lift modules (or Legs) that are attached to the bottom of the pontoon deck. The Legs lift and hold the boat at any height, up to six feet, from the lake or river bottom. When fully retracted under the deck, your pontoon is fully functional until you get to your next destination. To secure your boat, simply extend the Sea-Legs.

Sea-Legs were first installed commercially in 1994 and are protected by a U.S. patent issued in 1996. There are currently more than 2000 sets of Sea-Legs in operation in the U.S. and Canada.

Sea-Legs will fit on most 18 to 26 foot standard, new or pre-owned, pontoon boats. They are designed to optimally function on pontoons that have an 8.5' wide deck and 25" pontoons; however, 8' wide decks and smaller diameter pontoons can be accommodated.

One of the best benefits of Sea-Legs is the wide variety of applications that they can be used in. Raise your Sea-Legs and go, lower your Sea-Legs and park - at your dock, sandbars, restaurants, visiting neighbors, shore fishing, getting gas and more.

Sea-Legs are being used on all types of lake and river bottom surfaces. Whether you have sand, rocks or "muck", each independent leg has approximately 3000 lbs of extension and retraction power. Getting stuck is not an issue. Your local Authorized Sea-Legs dealer may have further information for you including recommendations and referrals from other Sea-Legs' owners in your area.

Sea-Legs will lift the deck of your pontoon six (6) feet, measured from the bottom of the pontoon deck to the lake or river bottom. In order to take the buoyancy off of the pontoons you need to be in approximately 4 ½ - 5 feet water. To have your pontoons fully out of the water, a depth of 4 feet or less is required.

The front and back Sea-Legs can be operated independently or simultaneously via the remote control or manual toggle switches. To compensate for different sloped lake bottoms, adjust the front or back height as needed. When fully retracted, Sea-Legs tuck to within 5 inches of the deck bottom, meaning they do not drag in the water as you drive. Sea-Legs' total weight is about 300 pounds, evenly distributed throughout the length of the boat. Sea-Legs' runs off standard marine-grade boat batteries. There is no need for additional power other than the battery you use to start your boat normally. We highly recommend a battery with at least 750 cold cranking amps.

Sea-Legs Standard (two-tube pontoon boats)
  • Two heavy duty hydraulically operated lift modules provide up to 5800 pounds of lift capacity.
  • Constructed of extruded aluminum alloy tubing and angled to provide strength and corrosion resistance.
  • Two large 18-inch x 48-inch pads support the pontoon on lake bottom.
  • Four hydraulic cylinders with steel alloy piston rods supply lifting power.
  • Sea-Legs attach permanently to your boat so you can take your lift with you wherever you go!
  • Lift height approximately 6 feet, measured from bottom of boat deck to lake bottom.
  • Single 1-hp pump tucked neatly under a seat activates the hydraulic cylinders.
  • Pump features an automatic shut-off alarm system to signal that the legs are fully retracted.
  • Sea-Legs are operated by either remote control or directly, via toggle switches located near the pump.
  • Maximum lift height approximately 72 inches from bottom side of pontoon deck to bottom of pads.
  • In retracted position, legs tuck neatly within 5 inches of pontoon deck; works with any pontoon trailer, no drag while in water.
  • Total weight added to boat approximately 300 pounds, evenly distributed.
  • No drifting, no anchors, no banging against the dock.
  • Two year limited warranty.     
  • When not in use, Legs fold up to within 5 inches of pontoon deck, for normal operation in the water or on any pontoon trailer.
Sea-Legs Triple Tube(three-tube pontoon boats)
  • Four heavy duty hydraulically operated lift modules provide up to 7500 pounds of lift capacity.
  • Four large 31” X 10” pads provide maximum support on any lake bottom.
  • Four hydraulic cylinders with steel alloy piston rods supply lifting power.
  • Single 1.5 horse power pump tucked neatly under a seat controls the hydraulic cylinders.
  • Maximum lift height approximately six feet from bottom side of pontoon deck to bottom of pads.
  • Sea-Legs attach permanently to your boat so you can take your lift with you wherever you go!
  • Total weight added to the pontoon approximately 500 pounds, evenly distributed.
  • Triple tube Sea-Legs are designed to always have two modules running at all times.
  • Works with most triple tube pontoons. Sea-Legs requires 13 inches of clearance between the center tube and the outside tube.
  • Sea-Legs is not designed to work with IO’s
  • The performance sheathing must be removed for installation.
  • Sea-Legs triple is operated by remote control allowing you total control of your lift.
  • In retraced position, legs tuck neatly within 7 inches of the pontoon deck.
Sea-Legs Canopy
  • Comes standard with Deckmate™ fabric in one of three standard colors.
    • Forest Green
    • Grey
    • White

  • Eliminate the hassle of playpen covers.
  • Lightweight yet durable all-aluminum construction.
  • Easy to assemble.
  • Augered posts secure canopy in high winds and rough water.